APPLE PLOT
Graph
creation program using Apple II graphics function.
To operate on 48K memory, Applesoft
Basic, in order to operate on Apple II, it is necessary to read Applesoft
Basic from Applesoft II Firmware Card or Language System.
There are 6 types of charts, such as bar graphs and
scatter graphs.
A data
conversion program is attached, and reading from VisiCalc is enabled.
Visicorp's
VisiTrend / Plot are the same graph creation software.
|
Program support tool for Applesoft.
It is used with DOS 3.3, add
automatic line number creation function, merge function etc.
The program resides right under the DOS area on the memory and resets the
upper limit (HIMEM) of the address where BASIC can write programs and
variables.
Therefore, even if BASIC is reset, it is devised so that the command can
be used as it is as in DOS.
Published in 1980, 33 pages, A5 version.
|
APPLE 6502 ASSEMBLER/EDITOR
An editor, assembler, command interpreter that can be used with Applesoft
or Integer Basic.
The Apple Pascal system has its own editor and assembler and does not use
this program.
The editor can handle up to 30K source code (1000 to 1500 lines).
The photo
on the left is the Japanese version, published by Toray Industries, Inc.
Published in 1980. # A2L0039 (030-0112-00) Japanese version, published in 1980, 85 pages, A5 version. |
A special binder of Toray's Apple II Applesoft Tool Kit (1980). It is splendid bounded very similar to the binder of VisiCalc at the time. |