Cards-1
|
|
| This card is installed in slot 0 on the motherboard. The switch is attached to the rear so that you can select ROM on the card or ROM on the motherboard. There are two types for AppleSoft and Integer Basic. |
LANGUAGE CARD
 |
| 16K RAM card. Like BASIC FIRMWARE CARD, install it in slot 0 and connect the terminal attached to the tip of the left cable to the socket from which the RAM at the upper left end of the RAM area is pulled out. The right end is F8 ROM. This is the auto start ROM. Since PASCAL LANGUAGE SYSTEM required 64K RAM, it was used to add 16K RAM to the main 48K memory. The upper card is made in USA factory, the bottom is made in Singapore factory. Part No. 670 - X 006. |
MICROSOFT SOFTCARD
 |
| Z - 80 Soft card. It will be able to run CP / M software on Apple II. |
SILENTYPE PRINTER INTERFACE CARD
 |
| Interface card for SilenType. It is featured to be directly attached by the 9-pin connector equivalent to RS-422 specification to the card Part No. 670-4014. |
PARARELL PRINTER INTERFACE CARD
 |
|
Parallel printer interface card.
It is designed to connect with 20 pin connector similar to DISK II
connector.
The setting can be changed with the JUMPER terminal on the right side.
The Centronics compliant Apple II Centronics Printer Card was attached
with a cable. A2B0002: Standard Card A2B0007: Centronics Card |
APPLE II PARARELL INTERFACE CARD
 |
| Parallel printer interface card. This one is new design. It is designed to connect 26 pin flat cable, and the setting can be changed with the switch on the upper left. Combined use with Centronics specifications. Part No. 670-0021. |
